Quote:
Originally Posted by MRX37
Well right now my concern is that u1001 IC. I'd like to know if there is a test I can do, maybe a voltage I can check or something I can measure with a multimeter that will tell me if that IC is bad. If I can at least get a concrete diagnosis then I can put the issue to bed.
|
Response to an earlier post: First, no way two CRTs would act exactly the same (unless it was mine). So we're talking power ball odds here. Also, I've never seen anything but a perfect picture on an RCA pre-yammed (their term) yoke with regards to purity, convergence, or tilt. Every one was damned near perfect. I only saw one yoke fail in all the years I was an RCA ASC.
The problem with this type of issue is that often our eyes are far better instruments than a scope would be. In other words, you may not even see the problem with the scope. This is one of those times when a parts swap is the best option.
If it was in my shop, I would have replaced the jungle chip, but then, we used to stock parts when these were in their heyday. If you've never worked on surface mount stuff, it can be daunting.
What is the number on the chip? Sometimes RCA just left the original Toshiba or Sanyo numbers on them, other times they were stamped with a partial RCA drawing number. If I have one, you're welcome to it.
John