The Zenith project is slowly coming to an end...replaced the last two paper caps that needed replacing and remounted everything in the case. I forgot how unwieldy the "all in one" Zenith chassis is to carry...
I get a pretty good picture (minus noise which I believe is due to a crappy RF modulator, as it also appears when connected to other sets), but the audio is incredibly buzzy. I know these sets are known to have buzz in the sound by design, but it still seems quite excessive and even overpowers the source audio sometimes (the severity seems to depend on the darkness/brightness of the picture). I've fiddled with the buzz control, but the change is almost negligible. I suspect there are some out-of-tolerance components in the audio circuit.
Tomorrow I will glue the broken knobs back together and drill some new holes in the front cover plate so it can be held closed by the springs again, as the original holes were drilled quite close to the edge of the metal and the springs wore their way through the metal until it broke.
Very close to wrapping up, it's been a blast!