View Single Post
  #25  
Old 10-24-2019, 02:42 PM
joe111671 joe111671 is offline
VideoKarma Member
 
Join Date: Nov 2007
Posts: 108
Quote:
Originally Posted by nasadowsk View Post
Horizontal line, or vertical line? A vertical line, a bit to the right (or was it left?) of the center, is a 'drive line' and just means the horizontal drive needs adjustment. Maybe you can have the same thing in the vertical? Check the output stage and any resistors there (IIRC, the vertical section uses resistors for dampers)
Horizontal line. It actually did have a vertical white line on the right that would get wider as I turned the horiz hold control, but that went away after I got the picture adjusted. I'll go check the resistors later when I get home. Can they be tested in circuit?

Quote:
Originally Posted by zeno View Post
If the white line goes side to side it may be vert fold over. Check the
resistors around the height & lin controls especially high ohms ones.
Also the 'lytic at the cathode of the output. That causes lin problems &
is common in most tube sets. Its usually in one of the cans.
Last thing is the vert integrator that 3 legged thing.

73 Zeno
LFOD !
All the lytics & paper caps are replaced with new. For the ones where the exact value wasn't available, I used the closest I could, and I believe all were within 10% of the original value. I remember seeing a youtube video by shango066 where he built a new integrator for an old Zenith. I'll have to go find it if all the resistors are ok.
Reply With Quote
Audiokarma