View Single Post
  #22  
Old 10-23-2019, 05:54 PM
joe111671 joe111671 is offline
VideoKarma Member
 
Join Date: Nov 2007
Posts: 108
As planned, I started working on the other Zenith. After it ran for a total of maybe 20 minutes, the picture started blinking now & then. I spotted arcing at the base of the damper tube. I subbed in the damper from the Zenith with the cataract and it took care of that. I was concerned that the set was causing the arcing, so I put that damper in the cataract set and it arced there, too. So I replaced that, made a list of all the paper & electrolytics that it has and placed my order.

Two vertical caps into it and the horiz output tube failed. I subbed the one from the cataract set and finished the recap, and it's been working pretty well. I've probably put about 16 hours on it so far and it's been very stable, I got the geometry as good as I can, but the vert linearity has to be all the way up to get it like this, and there's a horizontal line in the middle that's brighter than the rest of the raster. It's not visible in the picture, but it's definitely there. It doesn't show up till the set warms up and the vertical fills out, which takes about 5 minutes.

It doesn't bother me, but is this a telltale sign of something that needs attention so I don't damage anything?

I'm happy with it as is and I want to put the chassis back in the cabinet, but not till I'm sure it's good to go, as I don't want to pull the chassis out again for some trivial thing that I should have done.
Attached Images
File Type: jpg Jeannie.jpg (75.0 KB, 42 views)
File Type: jpg Indian head pattern.jpg (94.4 KB, 37 views)
Reply With Quote