|
Adam I think when I finally get this thing fixed I'll make a new thread with a step by step.
Also to both of you, as you can see the paper says horiz 10us div and vert .02v however it does not seem to show a useful waveform. I am also VERY new to scope and still do not fully understand how it works, so bear with me haha.
As we know already the color is pretty shot on this unit, and I might be better waiting until the new crystal arrives. If you look at this picture, when i turn AFT off, the color bars coming into the VTR are way off. which may be affecting the signal. See attached image. (The color bars from a few posts back was posted with AFT turned on)
Is there a way I can feed the NTSC signal right from the generator to the scope to use as a control?
|