|
So today I replaced all the caps and networks. When I applied power to the set, at first it did exactly what it did before (Fill the top half of the screen) The line at the middle and the over all picture was much brighter. Within a short time, the picture went to just a line in the middle. The v.lin pot started to smoke so I shut it down. Adjusted the pot and tried again and it did not smoke but it did not work either. I am perplexed. I did a quick check and did not see anything wrong but I am going to go over everything again. I did not remove the board, just clipped and soldered (Wanted to avoid this problem of it not working after a re-cap) Help.....
|