View Single Post
  #39  
Old 11-28-2018, 05:26 PM
ZenithNut ZenithNut is offline
VideoKarma Member
 
Join Date: Jul 2018
Location: Humboldt County, California
Posts: 78
Quote:
Originally Posted by Electronic M View Post
Definitely get a plastic alignment tool and stop using the metal one before you crack your slug... I've been there done that, and can say removing a crack slug without destroying the coil can be a royal pain in the butt... sourcing a new slug can be tricky too.

The only thing you will need to change on your scope is the vertical voltage scale. Composite video is about 1vpp and h osc waveforms in tube set are on the order of 50vpp...
How new your game system is can be important if you plan to use it as a H frequency reference. Older game systems used 240p rather than 525i. That change shifted the horizontal frequency a bit, and while most sets can sync to it I'm leery of using some random spec a programmer came up with because they were too cheap/reasource strapped to create a proper NTSC spec video source.

If you lost video and sound together you probably want to check tuner and IF systems. Wiggle tubes and if you get noise that stage and everything between it and the video detector diode are fine. In some cases the IF lead to the tuner will open or go intermittent... I have a CTC15 clone where the tuner and it's IF lead are permanently connected to the main chassis with soldered wire. The point the IF lead solders to the tuner has no strain relief so when I pull the chassis the center conductor of the IF lead tends to break off of it's tuner solder post... killing both picture and sound.

Do you have raster? If not check your boost voltage. Troubleshooting, adjustment and repair all get easier with the screen lightning.

Now that i think of it i dont have the antenna or uhf/vhf cables connected. Ill hook the tunner up as needed. I ended up using my super nintendo to get a nice wave form 9 divisions wide and 30 high. The sams says theres a waveform off pin 8 of the h osc tube. It was thinner and super high/long, not sure what exact words to use to describe it. Ill get a plastic hex as suggested. Since I wont be tunning the slugs with a metal hex ill do as much more as i can in this set then im gonna get (a much simpler) zenith bw tv going chassis 17T20.
Reply With Quote