View Single Post
  #9  
Old 07-20-2018, 08:02 PM
davet753's Avatar
davet753 davet753 is offline
David Thomas
 
Join Date: Mar 2013
Location: Knoxville, TN
Posts: 443
No, you don't want any grease on the rubber idler tires. If your platter speed is OK, and the change speed seems good, your idlers are probably working fine. You may need a little bit of light oil on the tone arm pivots; it is imperative the tone arm moves freely.

While you have the platter off it is a good time to lube the bearings. With the platter removed, you will see a washer on the bottom of the spindle, and some ball bearings. Just pull them off, clean it all up, and re-lube. When it's right, you can spin the platter with your hand and it will keep on turning for quite some time.
Reply With Quote