View Single Post
  #3  
Old 08-25-2017, 10:56 AM
FrankieKat FrankieKat is offline
VideoKarma Member
 
Join Date: Feb 2012
Location: Brooklyn, NY, USA
Posts: 42
Quote:
Originally Posted by Electronic M View Post
If the noise goes away completely with the IF tubes pulled then the problem is either up stream of the 1st IF tube you can pull to kill the noise or it is in the AGC.
With all three IF tubes removed and the IF signal injected afterwards, same issue.

Quote:
Originally Posted by Electronic M View Post
If the noise goes away with the 1st IF tube pulled, then odds are it is in the tuner, or it is local interference. If you have a signal source that operates on other channels than the one your currently using it may be wise to try different channels. There is a large gap (FM band + other stuff) between channels 2-6 and channels 7-13. So switching from low band VHF to high band or vice-versa may be a wise test (to get away from wide band noise). Also if a local DTV channel is using the same RF carrier freq as your signal source, you will likely get noise from that DTV carrier leaking into your set.
I used the VA62 to try on channels 7+ and still there. The DTV box is only 3 and 4, but same on both.

Here's what I'm seeing now with VA62 feeding channel 3 RF: https://youtu.be/q8nD70vokkE

It's odd that the audio takes hits too because it's picked off immediately after the detector which is basically right after the IF injection point that I used. Would this seem to suggest the issue is in fact HV-related since that would be about the only thing remaining that could cause this effect on both audio and video?

Quote:
Originally Posted by Electronic M View Post
One way you can eliminate AGC noise is to connect the AGC buss to an external adjustable DC supply 0-25V and use that supply to clamp the AGC line to a proper fixed voltage.
I used the VA62's DC output to vary the AGC voltage and that actually did what the AGC control is supposed to do. Also, with at least -5V applied, the AGC control does actually have an effect on the picture( for the first time) since the injection point is at the wiper of the AGC control. Without it, at that point, I measure a small negative voltage only in mV that varies maybe 8mV with the rotation of the AGC control. With just the VA62 connected with the voltage set all the way down to nearly nothing, the picture does become slightly more saturated - like the AGC control being turned slightly up.

There are otherwise no voltage readings called out on the schematic for that portion of the circuit so I'm confused as to where this negative voltage would be normally developed? I should expect to see that same between -9 (or so) and 0V at that point if everything was working correctly yes?

Thanks!

FK
Reply With Quote