|
I don't know but would heater voltages reflect on the drop in b+ , I ask because I can't seem to get the right ohms readings from several tubes on this set using both ts4j early and late prints along with the ts18 print all show close to the same ohms reading but I'm getting totally different readings so with the b+ down between 82-90 Vdc from 125 Vdc I'm wondering if something affecting the heater voltages if this may affect the b+ . While the 6al5 pin3 7 ohms I'm getting 22 ohms and pin 4 1 ohm I'm getting 16 ohms. V6 pin 3 11.5 ohms I'm getting 22 ohms and pin 4 , 7 ohms I'm getting 18 ohms this don't seem right yet the voltages are ok on v, 2,4,10,11,13,6. It don't make sense that b+ is so low there should be something obvious but I'm not finding it. Any help would be great at this point.
Last edited by timmy; 08-07-2017 at 08:39 AM.
|