I did the IF strip today. The chassis is basically been re-capped etc.
I installed some Y2 safety caps and one of them went to the switched AC power from the on-off switch to the transformer. Remember when I redid the volume pot? The one wire was chaffed pretty good on the chassis and I cut out that section and installed about a 4 inch piece of new wire under the chassis. That wire was the one that needed the safety cap. I installed a terminal strip and spliced a wire into the switched AC power and ran it to the terminal strip. I then installed the safety cap.
I'm in the middle of cleaning, lubing, and checking the back panel pots. When those are done, then the speaker and mount gets cleaned up and re-installed.
BTW, I have a APB for a electrical dual coil Ion Trap in the classifieds. Mine came with a resistor across the leads and a Dual PM Ion Trap.