|
A couple of volts off at the Horiz Osc grid is OK ... look at the scope trace,
its 30V P-P.
That circuit is hopeless to diagnose if its not working close to properly.
Make two tests: first look at test point 60 on a scope ... is it right?
Second ... WITH THE SET OFF feed the biggest voltage square wave at 16 kHZ
your generator can muster into the plate cap of the horizontal output tube.
Scope point 61 (aka 101). You should get something ringy looking there,
problems with the horizontal output transformer or convergence
board could cause problems, especially a short on the convergence board.
(You should try the thing with and without that plugged in).
I had a fault in that circuit on my CT-100 that was fixed only
by shotgunning all, and I mean all, non-coil parts. And it was still
working ... scoping did not help.
I would shotgun everything except coils.
|