View Single Post
  #57  
Old 09-10-2016, 10:33 AM
madlabs madlabs is offline
VideoKarma Member
 
Join Date: Jul 2016
Posts: 389
OK, in the absence of a CRT tester/rejuvenater, I am looking at options for trying to wake this tube up.

1) In circuit, reduce the ballast resistor value, either by replacing one of the sections with a lower value or putting a variable power resistor in parallel. Check the voltage delivered with the CRT filament out of circuit and a 3.9 ohm resistor subbed in. Target voltage 2.34 volts * 1.4 = 3.22 volts. 5-25 minutes. Questions: Video signal or no video signal during rejuve? After rejuve, increase nominal filament voltage by about 15% (2.8V) as with a tube brightener?

2) Make a rejuvenator like one of these two, one is a link, the other a PDF attached. While similar, both have some differences. I have the stuff for either. Seems like it is a more of a real rejuvenation as opposed to just upping the filament voltage.

http://www.thevalvepage.com/teletech...ej/crt_rej.htm

I'm thinking the answer likely is to try #1 before moving on to #2. It would be real nice if I could get some life out of this tube.

Thanks for the help!

JOnathan
Attached Files
File Type: pdf CRT rejuvenator.PDF (147.9 KB, 14 views)

Last edited by madlabs; 09-10-2016 at 10:37 AM. Reason: Forgot link
Reply With Quote