View Single Post
  #5  
Old 08-23-2016, 10:32 AM
DavGoodlin's Avatar
DavGoodlin DavGoodlin is offline
Motorola Minion
 
Join Date: Aug 2011
Location: near Strasburg PA
Posts: 3,505
The Audio generator used is an EICO 378 with 600 ohm balanced for external load.
I pulled the driver tube and connected the output to the primary of the phase-splitter ( output driver) transformer and got 500Hz nice and clear - power supply and output are cleared!

Next was the 2nd detector - across grid and cathode - louder this time, cleared this stage.

Just skipping over the IF stage its plate voltage was OK, then I checked the 1st detector (oscillator) and the plate was zero volts to B-. Checked terminals on can to verify the open primary.
I pulled the can off and saw the telltale green specks on the winding just above the solder terminal. This coil looks wind-able if I have the right wire but Im trying a surgical repair first.

Thanks for the help!
__________________
"When resistors increase in value, they're worthless"
-Dave G

Last edited by DavGoodlin; 08-23-2016 at 10:37 AM.
Reply With Quote
Audiokarma