Quote:
Originally Posted by Electronic M
My interpretation.
1. Set IF amp grids to -3 by use of picture control or external bias supply if needed.
2,3. Max indication = highest (in this case voltage) reading the circuit will give your meter while making the adjustment, and Minimum indication is lowest indication circuit will give. (I'm surprised this is confusing.)
|
It's not so much that it's confusing, more that I've never done this before and I want to make sure. It's always better to ask questions from experts than to just assume you know what you're doing. The thing that really made me ask was the fact that the instructions were seemingly saying to maximize voltage readings at various points, but then saying that if voltage got too high it was a bad thing.
I-f oscillation shows up as a voltage in excess of 3 volts at the picture detector load resistor.
As to my last question, should I always use a capacitor to couple the signal generator to the i-f amplifier grids?