View Single Post
  #29  
Old 03-23-2016, 07:27 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
It should have a height adjustment, usually one of the controls on the back edge that doesn't have an extender on it.

You don't need (or want) to remove the PC board, just the metal shield that's covering the back of it, that is held on by several screws around the outside edge and several tabs that are soldered to the board.

If the Caps you couldn't replace are in the vertical circuit then they are probably causing the problem. Those sets are difficult to get good vertical adjustment on their best day, anything out of spec will only make it worse.

Some of those odd caps like the .0039 and the .056 are 10% tolerance so if you replaced them with .033 and .047 it could also be affecting it.

Check the resistors in the vertical circuits, they are pretty critical.

If this is the model that uses a 6AQ5 for the Vertical output try swapping it with the 6AQ5 in the Audio and see if it changes anything.
Reply With Quote