View Single Post
  #15  
Old 03-12-2016, 07:43 PM
Captainclock Captainclock is offline
Banned
 
Join Date: Dec 2013
Location: Elkhart, Indiana
Posts: 1,189
Quote:
Originally Posted by Ed in Tx View Post
Good to know super glue will hold that type of plastic. When I did it for a living and charged customers money, and had to guarantee the repair, I never tried gluing a gear. But nowadays you have to improvise.

I did have a few Sonys that developed a loose pressed-on worm gear on the load motor shaft and rather than have an estimate declined to replace a very expensive assembly, I would take the motor out, file a flat spot on the motor shaft, degrease the pulley and shaft and apply a tiny bit of JB Weld. I knew that sucker ain't spinning on the shaft again!
Welll my glue job on my gear didn't hold up like I thought it would sadly enough. And I went to look on ebay to see if I could find a parts unit and sure enough they had about 15 of these VCRs listed on there but all of them wanted over $300+ for them, there was one VCR that had a video dropout issue but otherwise a mechanically sound unit for $29.95 buy it now price, but they want $35 for shipping which I can't justify that to my mother.

Last edited by Captainclock; 03-12-2016 at 08:44 PM.
Reply With Quote
Audiokarma