|
The smaller tube is likely the horizontal oscillator. If this tube fails, it will cause the 6JE6C output tube to fail as well due to loss of grid bias. The output tube's plate current will rise uncontrollably without this bias voltage present on the control grid, destroying the tube in short order. Replace the horizontal oscillator tube first, before anything else. It might not be a bad idea to replace the output tube at the same time; it may have been damaged when the oscillator tube failed.
Note as well if the horizontal oscillator stops for any reason, in addition to damaging or destroying the output tube the power transformer could burn out as well. This is caused by the excessive current drawn by the HO tube without grid bias.
Do not operate the TV if the oscillator tube is defective; there is no point in doing so anyway, since there will be no raster if there is no high voltage. All TVs made after about 1950 derive the CRT's high voltage from the horizontal scanning and therefore depend on the horizontal oscillator and output stages' correct operation; if either malfunctions or fails for any reason, the HV will stop as well and, as I mentioned, the power transformer could be damaged.
__________________
Jeff, WB8NHV
Collecting, restoring and enjoying vintage Zenith radios since 2002
Zenith. Gone, but not forgotten.
|