View Single Post
  #3  
Old 01-31-2016, 09:36 PM
dieseljeep dieseljeep is offline
VideoKarma Member
 
Join Date: Jul 2010
Posts: 7,562
Quote:
Originally Posted by Hcompton79 View Post
Update:

I replaced all of the paper and electrolytic capacitors and while I now have wonderful sound, I've lost the raster. I noticed that the HV rectifier was not running, so I did some checks to make sure the flyback wasn't shorted out and it wasn't. So I pulled the horizontal output tube cap off and used an insulated screwdriver grounded to chassis to try and draw a spark off the cap which I could not do, I believe this means no RF is going to this tube, correct?
what should I do now?
Don't touch the horiz output plate to ground. It draws too much current and can damage the flyback and the horiz output tube.
The HV supply circuit is protected by the 4/10 amp fuse, the only one in the set.
If the horiz output tube isn't getting drive, the tube will red-plate.
Reply With Quote