View Single Post
  #74  
Old 10-23-2015, 10:38 AM
Gregb Gregb is offline
VideoKarma Member
 
Join Date: Jul 2014
Location: Edmonton Alberta Canada
Posts: 548
I know on my set I had noticed the high voltage lead was all covered with I assume corona dope or something like that. I had measured very low HV and I could hear some arcing but could not see anything. I changed the lead out for some new stuff and the HV came right up to where it was supposed to be and got a nice bright picture.
I also cannot see the filament glow on the 1V2 when in the operation but due to the correct HV I can safely say it is working properly.

Gregb
Reply With Quote