View Single Post
  #6  
Old 10-18-2015, 08:01 AM
Olorin67 Olorin67 is offline
VideoKarma Member
 
Join Date: Feb 2014
Location: Milwaukee
Posts: 927
most tube tester makers sold accessories to test tubes with more pins on older testers. If you see tube data in your roll chart for 12 pin tubes, and your tester doesnt have a socket for them, an adapter is needed. Usually this is stated on your set-up chart.

testing tubes in the set is always preferable, if you have a known good tube to compare with. thats the only way to confirm that a tube is good enough to work in your set A lot of times a tube that tests marginal will perform just fine in a set, but some circuits are finicky, and even tubes that test good will not work in all circuits.
Still good to have a tester, even an emissions tester, to weed out tubes with weak cathodes, or shorts. And if you dont have a stash of replacements for every tube in your sets, a tube tester is valuable to see if a tube might be an issue so you know what tubes you need to buy. I have a lot of tubes on hand, but a lot are used pulls I got at hamfests, so I always check them before I sub them in a set to see if there is improvement. I have a Hickok 6000a that covers modern tubes and compactrons, a Hickok 600 that has pre-octal sockets, and an old weston that tests early tubes. you cand find testers in odd places, I found one at a junkyard/surplus dealer, the 6000a for $40 at an antique mall (next to a cheap Knight tester with a nicer condition case for 3 times the price), and the 600 from a co-worker who heard I fixed old radios, and was cleaning out an estate.

Last edited by Olorin67; 10-18-2015 at 08:09 AM.
Reply With Quote