View Single Post
  #17  
Old 09-16-2015, 12:44 PM
dieseljeep dieseljeep is offline
VideoKarma Member
 
Join Date: Jul 2010
Posts: 7,562
Quote:
Originally Posted by ohohyodafarted View Post
The correct answer is DO NOT REMOVE THE TENSION BAND WHILE UNDER VACUUM

I watched Scotty at Hawkeye do some rectangular tubes for bowling alley monitors. The band was removed only after the crt was at atmospheric pressure. After the tube was rebuilt and under vacuum, the final step was to replace the tension band using steel strapping like is used in strapping wooden crates. A special tool is used to apply the tension on the steel strapping and then another tool is used to place a clinch fastener to hold the bands tight. All done while tube is under vacuum. When I saw Scotty fasten the new band and tension it, I was afraid it would implode, but actually the tube is more likely to implode with the band removed.

I would use a high speed carborundum cut off wheel to saw the ears and remove them.

Bob
They're available at Harbor Freight. The $9.95 4.5" angle grinder is good enough for the application.
Reply With Quote