|
Normally when Zenith yoke covers of that period disintegrate the only damage is cosmetic....If those terminals are still exposed with the cover and centering rings pushed back, then remove the cover, and cut a circular piece 1.5" in diameter bigger than the yoke, with a hole in the center big enough for the neck out of a 1/32" or thicker sheet of plastic....This will prevent you from accidentally touching the yoke terminals while adjusting centering (a very painful experience!) or the rings shorting those terminals.
You could even leave the yoke be until the set is working and you are contemplating adjusting centering....It really should not be an issue.
|