|
Hi, Looking over the specs' of the two CRTS the 16BDP4 has a 450 ma. heater and the 16BNP4 has a 600 ma. heater. Also the 16BNP4 only needs about 30 volts peak to peak drive signal. Where as the 16BDP4 needs 100 volts peak to peak drive signal. The G-2 voltage and heater current can be taken care of just by using resistors. The 100 volt peak to peak video drive signal not so easy. You should test the CRT maybe a lite cleaning on restore mode of a SENCORE tester is all it needs. I would try a pass on the CRT tester and keep looking for a tube that has specs close to the tube you half now, but make sure it is a low drive tube. All the best,tom.j.fla
Last edited by tom.j.fla; 09-05-2015 at 01:42 PM.
|