View Single Post
  #47  
Old 07-13-2015, 10:42 PM
dtvmcdonald's Avatar
dtvmcdonald dtvmcdonald is offline
VideoKarma Member
 
Join Date: Nov 2012
Posts: 1,268
Yes, I knew aquadag was useless for such a set. But I had recalled somebody
saying it was there.

Incidentally Steve, I found the CRT base pin assignment, it was on
a paper formerly glued to the base but now loose.

I looked at the alignment: the video IF as amazing: it looks like the CT-100
its so good. The RF was not so good: on neither Channel 3 nor 4
was the audio really in range of the fine tuning though you could
hear sound. And 3 and 4 were off in opposite directions. And the
correct spot was out of range on the adjustments by a lot. I got Ch. 4
OK by a slight bend of the strap but Ch. 3 required that I solder
a copper strip 1/4 inch wide to the tuning loop to get the inductance
down a bit. The tuning adjustments for the antenna coils were
well within range and were quite a bit off of flattest response.

Oh yes: the audio carrier ended up at 8.11 MHz.

Last edited by dtvmcdonald; 07-14-2015 at 10:16 AM.
Reply With Quote