|
I was wrong about the oscillator frequencies, it was
nearing midnight and I was blindly comparing to
the channel limits printed on the set, not modern
ones. They are still the 1941 set, i.e.
the set with one channel at 50-56 MHz. This means only
channels 3 and 4 work with modern signals.
There is no "major" oscillator adjustment in the set,
so I'm leaving it as-is.
The problem pot was taken apart and examined. I could find
nothing wrong with it, so cleaned it up, used deOxit on it and
added a Mylar film insulation layer between the terminals
and the case front, which was uninsulated and rather a close
gap. It now works fine. This was a really high-class part
in its day.
A photo of the chassis at present is attached. The big blue
13K power resistor is obvious. There are numerous Nichicon
radial electrolytics scattered around .. some are invisible in
the photo. Only one small resistor was replaced, with a modern 1/2
watt carbon one (the one meg one). Other ones of that sort
were original. There are two unrestuffed .005 uF caps, due
to worries about installation damage if restuffed. There are
also of course the two silicon diodes across the two missing tubes.
I now have to await word on what the radar CRT connects are,
make a protective box for the 7.5 kV rectifier, and make an
HV connector adapter. It also needs a small
dropping resistor, only 5 to7 volts..
|