View Single Post
  #17  
Old 07-09-2015, 03:05 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by Electronic M View Post
You have some of that wire that has not rotted and shorted out it's set!?!?

Virtually every rubber wire I've seen was dried and cracked or getting there....I pretty much reflexively replace it now.
Agree - replace any rubber wire that is cracked. If glazed (can't clean gunk, but it is still flexible), use Rubber Re-nu from Rawn. When I was in the Calibration Lab, we used the stuff by the quart to keep expensive cable assemblies clean and flexible. We're talking cables that were immersed in water/oil, fuel and other contaminants on the flight line, so they got gunked up. Rubber Re-nu, if it is still the same formula, STINKS, so use it sparingly and outside if possible. I get a headache if I even smell anything close to that smell.

We also used it to revitalize/deglaze rubber on phono idler tires. Makes them last - we replaced very few idlers on BSR, V-M, Garrard and Collaro changers, thanks to a little bottle of the stuff.

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote