Update: all the sweep caps and the synch peaking coil are replaced, and as many know that can be a hassle in a "layered" chassis. Now will install the replacement synchro-guide tapped coil. One question about that: the schematic and the replacement coil spec sheet do not indicate which side of the center tapped coil go where. After consulting an RCA schematic for the CTC-11, it looks like the higher resistance winding goes to the plate of the oscillator, and the lower side, after the center tap, goes to the grid. Can someone offer guidance on this please?
EDIT 7/10: it actually is the other way, low to plate, high to grid.
I've been fortunate to find on ebay a Wallace's Telaide with the waveforms, etc., but don't know if it would have the resistances of each winding noted.
Anyway, I'll go ahead and connect it up according to what I've found, and just proceed carefully. Not the easiest chassis to work on, but if all goes well I think I'll have a decent TV on which to watch B/W programming.
Last edited by stromberg67; 07-10-2015 at 05:00 PM.
|