View Single Post
  #21  
Old 07-06-2015, 05:24 PM
Captainclock Captainclock is offline
Banned
 
Join Date: Dec 2013
Location: Elkhart, Indiana
Posts: 1,189
Well I removed the 1V2 HV Rectifier Tube tested it (along with the rest of the tubes on the set) and everything tested perfectly, and so I put the tubes back in and plugged the tv set in and powered it on and sure enough after about 2 minutes I had a picture and it was a pretty decent picture at that (so I'm guessing the picture tube is still good), the only issue I saw was that the the height was not correct (it was too short the picture was relative to the actual picture tube size) and I tried adjusting the height adjustments and what not but the picture wouldn't fill the whole screen for some reason, which I'm wondering if the vertical Amp tube is about shot in this case.

Any ideas?

Like I said when I finally got picture it was pretty bright and seemed like it had plenty of life in it yet (the filaments were glowing nice and bright yet) just the height was out of wack and couldn't be made right with the adjuster on the back.

EDIT: The TV is now back to stage one where I had no picture (well actually it has picture but its barely visible) and it started doing this when I put the cover back on, but when the cover was off it was working just fine (minus the height being off) so I wonder if the 1V2 tube has a short in it that didn't show up on my tube tester, either that or the tube is actually just about shot but my tube tester for some reason thought it was still good.

Last edited by Captainclock; 07-06-2015 at 06:32 PM.
Reply With Quote