View Single Post
  #12  
Old 06-10-2015, 12:29 PM
fixmeplease fixmeplease is offline
VideoKarma Member
 
Join Date: Apr 2015
Posts: 240
Thanks for the advise and I am just reading it. Several e-caps were way off, over double high, and I replaced them all yesterday evening. The TV has been worked on a few times and has had a few regular caps replaced before as the soldering didnt lie.(e-caps were original cans) Several of the other caps were off 25-50% with one double. I had the caps already, so this morning I just replaced all of the tubulars but 1. The brown and red ones, some were ok and 2 werent. I replaced the bad ones. I had already tested the tubes a week ago with a tester I bought and had boughten replacement tubes and it needed 6. It does have a couple bad resistors I found while replacing caps but I will leave them for now.

I figured I was going to have to replace the e-caps sometime, and now I have one less worry.

worse case I can remove the parts I added. I didnt mind spending the few hours it took as I learn from doing, as they say.

Now I am just waiting for my isolation transformer to arrive! It is kind of a variac too, its an isotap WP-27a. The TV is sitting on its original stand waiting.

Can I still test it for shorts as mentioned and do I remove the horiz out tube to do that part? Different paragraphs so I'm not sure. And if its 8-12K, then that means it has a short? or is good?

I do really appreciate the advise and support. Thank you
Reply With Quote