[Mr.B&W]

hey guys, thank for all the helpful posts, well after I replaced the the electrolytics in the vertical circuit, IT HAD A PICTURE, but it still had a tendency to roll, which it didn't do before so I don't think the vert. hold pot is bad for now, but anyways I just figure ill go ahead and continue recapping, so I work my way through the horizontal and the Sif circuits, and test it again...DAMN now its just an even worse linear mess!, I'll attach an image of the symptoms later, I have several theories as to why this happened 1. I substituted two 33UF 50V caps for a 33UF 25V and 33 UF 16 volt in the Sif circuit, and in the horizontal circuit I substituted a .033 film cap for a .027 film cap, Could these voltage differences be causing this? 2. I'm thinking this has got to be in the vertical circuit somewhere but I've poured over it and cant find anything, every cap in that circuit was replaced exact UF and Voltage except for a 4.7 UF 50V for a 4.7 UF 16V, again possible voltage problem? or 3. there is a 2.2 UF 250V capacitor that sits in between the vertical and horizontal and unsoldered it to see its value but since I didn't have one I just soldered it back in, could that have caused that cap to leak or something? , I haven't been able to find a schematic so far so that the best I can do, I'm sure I probably made a rookie mistake in here somewhere, but I'm stumped, thanks guys