View Single Post
  #164  
Old 04-14-2015, 09:01 AM
Username1's Avatar
Username1 Username1 is offline
Not sure how I got here.
 
Join Date: Dec 2009
Location: Orange County NY
Posts: 3,668
Well who knows you might get off easy and not have to take apart the entire unit....
Lots of current runs through that little thingie, so be sure you use a large wire
when soldering it onto that lug/rivet.... Try and use multi-strand wire so you
have a bit of flexibility and you might as well do both sides, and remote
tie it to the plug wires, keeping the plug in the circuit in case you need it
later on.... If it works just seal off the plus holes so they don't corrode....

On old car doors like that, it is best to do all the work you can on one removal...
The crappy card board they made them with will get soft with each removal
and re installation... So fix it right, replace the speaker, clean everything,
spray some rust repair paint in the bottom, vacuum out the bottom of the
door where the drain holes are..... And be sure you carefully repair that
plastic water barrier that protects the cardboard.....

And if the window isn't running up and down right, or is a little too loose,
this is a good time to snug up the glass guides, and lube the runners....
Be careful what you lube everything with, or even if you should...
Our Honda Accord I have to use Armorall for lube it works best, as
the parts are rubber.... Some Ford guides are some cloth based stuff
and for the most part don't need lube.... If it seems to vibrate, or
semi-bind as it moves, my favorite dry lube is Chapstick.... Great for
key locks too by the way... House of car....

Anyway, check out everything possible while yer in there.....

Good luck and have fun !

Hey my finders had all those "Ford Dings" on them every time I had to
work on my car as well..... I think they planned it, 7" away from each
nut was a sharp piece of metal, or some other screw from the other side
positioned just so that when yer wrench slipped, there was some
sharp thing to say "Thanks for buying a ford, oh by the way, you need
a band-aid."

.
__________________
Yes you can call me "Squirrel boy"

Last edited by Username1; 04-14-2015 at 09:13 AM.
Reply With Quote