|
The vertical buzz is most often caused by the output transformer. I'd do the variac test on the output, then if it shows deflection go back to the oscillator.
If you're squeamish about the variac test, then here is another idea connect pin 2 of the 12AU7 to the non-grounded heater line through a large film cap (something like .047 to .47 should work) and see if you get any deflection. If you do it proves the output stages are working, if not then you need to work on the output stages first.
Everything before (read left of) C87 should be ignored for now. That stuff is part of the synch separator, and you should have vertical oscillation and deflection even if C87 were to be cut out of the circuit.
Last edited by Electronic M; 04-10-2015 at 12:03 PM.
|