View Single Post
  #20  
Old 04-02-2015, 02:55 PM
rca2000's Avatar
rca2000 rca2000 is offline
VideoKarma Member
 
Join Date: Mar 2003
Location: cincinnati,ohio
Posts: 2,090
Ok....the FIRST thing you need to do....is to see if your MINUS 12 volt supply (this set has a POSITIVE ground--since it of all PNP topology--even the H-out) is there and correct.

Go to that big transistor on the big sink--right side of set--looking from rear. From ground--you should see a negative 12 volts on the collector when the power is turned on. (one thing to remember...this set does NOT switch the primary of the power tranny off--it has voltage all timers when the set is plugged in--but there is NO instant-on ckt). if it is NOT there--check the emitter of the transistor--and see if -15 volts or such is there. If NOT_-perhaps there is a problem with Q-25 or Q-24 (these are labelled as "x" as per the old same nomenclature). both of these are up front on the chassis, left side--near the V-out trans. There is also a zener--x24, off of the emitter of x25, the error amp--that could be shorted. It appears to be a 6.5 volt zener. The CATHODE of it goes to the emitter--NOT the anode--since this is a - supply.

If the -12 volt supply is there....go to the power switch ans see if it is going through that. There are two sections--one has the battery supply on it=--the other out of the rectifiers. If ok here ...go to that fuse by the HV cage. It should be on that--both sides.

If all that is ok...(and i expect that is will NOT all be ok--if you are getting NO sign of power..Make SURE the ac/dc switch on back has not gotten all gummed up or such. this is by the battery connector--and looks like it interrupts ground path. It goes into "dc" mode--while the power plug is inserted into it.

Somewhere--you will find an open ckt. BTW_-that big black cap o bottom is 4000 uf--so a 4700/25 would work fine for that one.

Last edited by rca2000; 04-02-2015 at 02:57 PM. Reason: Mistakes.
Reply With Quote
Audiokarma