ok so leaving the .01 disconnected didnt last its rolling again so i put it back. i looked at near everything here and it just wont stop rolling. i subbed tubes, mica caps, verticle hold pot, for the verticle and horizontal micas as well and all makes no difference. , there has to be a reason why it wont stop rolling all the caps that came out were put back with the same values. i went over everything i did and cant find a thing wrong. does anyone know where i can go from here because i am burned out at this point and maybe someone out here can mention something that i missed. i cant get an acurate voltage reading on tubes in the verticle circuit because the voltage is all over up and down as it rolls out of control. i dont know if the horizontal may have something to do with verticle or is upsetting it for some odd reason. right now the horizontal is ok just alittle short on the width. so maybe something is interfearing between both vert and horiz and the verticle is taking it the worst. HELP
