View Single Post
  #38  
Old 02-20-2015, 08:34 PM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
Quote:
Originally Posted by Tubejunke View Post
25Kv is generally where most people seem to set them and many manufacturers recommended. The efficiency coil is used to set the cathode current of the horizontal output tube. You have to place a meter in series with the grounded cathode of the tube. There are a few opinions on the ins and outs of how the meter is set up, but I simply broke the cathode to ground connection and ran two leads out so I could check this current anytime I want. Some people believe in placing a capacitor across the two leads to protect the meter. You may want to look into that, but I didn't worry with it and had good results.

Other than that you operate the set normally and turn the slug slowly and find what is called the "dip" point or the point where the lowest current flows and that's about it. If you are like me, you won't be satisfied with that current as it may still be too high due to some other component causing that condition. I hope this helps. I think you can Google setting the cathode current on a vintage color television" and there is a pretty in depth article on this topic, but it is a bit scattered in nature. If you find it you will see what I mean.
You will not get an accurate current reading without that capacitor. The inductance of the meter will change the tuning of the output circuit, and you will get inaccurate readings.

Try it again with a .47uF cap (any voltage >10 should work). You should get different readings, and they may be lower....

Remember the goal of measuring equipment is to load or disturb the behavior of the circuit under test as little as possible. The meter will have very low DC resistance, but may have higher AC impedance, the cap neutralizes that impedance by giving AC an alternate path to follow.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote