View Single Post
  #32  
Old 02-18-2015, 09:47 PM
Tubejunke's Avatar
Tubejunke Tubejunke is offline
VideoKarma Member
 
Join Date: Apr 2003
Location: Martinsville, VA
Posts: 1,823
Quote:
Originally Posted by dieseljeep View Post
The way I found the socket, the filament went to pins 9 and 12. The regulator plate lead went to pin 9 and jumper went from 9 to 4. The 2nd anode lead went to pin 4, as well as the jumper going to the metal cup.
I, like a fool, removed the jumper and installed the resistor. It looked like the jumper was installed by a tech. Didn't look like factory issue.
Just remove the resistor, install the jumper and wire, per these instructions.
OK, so my thinking was right about it not making sense to connect both ends of the resistor or jumper to internal cathode connections. #4 being an NC (no connection) will just be a tie in as someone else has mentioned. I was just mixed up between 4 and 5 which in my socket are both pulled out and there is just a hole there. Anyway, I will give it a try hopefully this weekend.

Thanks!
__________________
"Face piles of trials with smiles, for it riles them to believe that you perceive the web they weave, and keep on thinking free"
Reply With Quote