|
Think of AGC as a sort of automatic RF system amplification factor adjustment. Basically a TV is a video monitor with a fancy radio attached. The video monitor portion expects the video signal along with the synch pulses and color information it contains to be one specific amplitude. The signal the monitor half gets from the video detector at the end of the receiver portion would naturally vary in amplitude in step with received signal strength if it were not for the AGC. AGC controls the receiver gain so that the signal out of the video detector is the same no matter what the signal strength at the antenna is. How it usually works is by measuring the level of the horizontal synch pulses and comparing them to a fixed reference, and generating a error voltage that is sent to the tuner and IF stages to adjust their gain so that the error goes away.
Look for a block diagram of a color TV set with explanation of the blocks, it will help you understand what is going on.
Edit: I don't think we sold tube sets with that style of tuner. It should not matter if the tuner section is right because most sam's did not explain how to change the dial light, or clean the contacts which are about the only service procedures someone without a LOT of experience and specialized RF/IF alignment equipment has any business doing to a tuner.
Last edited by Electronic M; 01-24-2015 at 10:26 PM.
|