View Single Post
  #84  
Old 01-15-2015, 09:35 AM
timmy's Avatar
timmy timmy is offline
VideoKarma Member
 
Join Date: Jan 2011
Location: Delaware ny
Posts: 3,719
Quote:
Originally Posted by Username1 View Post
Timmy; Be aware that coils, and capacitors act on the signals coming through them so
to speak.... The raw DC off the damper is pulsed at 15K/cps. The voltage needs to be measured
at a point specified by the schematic. There is no way of knowing what is at the Damper
cathode, and no way of knowing what it's going to do to your test equipment....


Or if it's going to read it correctly....

My schematic is only that, I don't have a full service manual, and do not own a set like that,
or have recent experience on it.... SO be careful... Only use the HV probe.... ***

But There may be some validity in checking around there.... Because you say that you have
had retrace lines on the screen.... And I remember you saying something about how the
screen controls are set..... Do you always have retrace lines on the screen, no matter
what the brightness / contrast setting...?

Do you have a nice color picture that is for the most part accurate, and watchable...?

What company made the new flyback..... Do you remember OEM or Other....?


.
well i will use the hv probe in that area to get an idea whats there. the flyback is a thordarson 273 and so was the one i took out. the color drives, rgb are fully counterclock, off and with them down like this i dont have the lines and i dont think its retrace but rather these color drives appear to be driven to hard by adjusting the right way in the setup mode maybe because of the lack of hv these drives need to be low to be even for the amout of hv present. set this way the picture is good but on white scenes its a different story or other scenes the colors will change alittle and or the pic will pull in alittle at one end. but is watchable. if i set the colors up the right way i have rgb lines across the screen and lots of blooming and brightness and contrast up or down makes no difference. right now with the drives down i have no lines and a decent picture but it is far from right and i dont want to leave it like this after spending so much time looking for this problem to just leave it alone now. the only thing i have to test a hv source like around the damper is the hv probe and i have been shocked many times, i dont like it but i try to be careful.
Reply With Quote