View Single Post
  #8  
Old 11-20-2014, 07:21 PM
old_coot88 old_coot88 is offline
VideoKarma Member
 
Join Date: Sep 2009
Posts: 2,654
Quote:
Originally Posted by Geoff Bourquin View Post
I wouldn't think pulling power for low voltage loads would be good for the horizontal output/damper tubes.
Very true. The H.output tube in particular, just to drive the yoke and sustain HV, is already running near its maximum plate dissipation rating. Further loading would push it into red plating.
Tubes are inherently lossy compared to 'hard' SS devices (e.g., power transistors and SCRs) which can drive and sustain a much 'stiffer' supply than tubes can.
Quote:
A tube rectifier for low voltages would have been terribly inefficient.
True, and for the same reason. Too lossy compared to SS diode.
Quote:
Also, in the tube days were there any solid state rectifiers that worked well at 15.75 kc.?
Well, there were selenium stacks used in convergence panels in color sets. Also the boost diodes and 'stick' focus rectifiers in color sets were selenium, as well as stick HV rectifiers in BW sets.
Gotta remember HV is generated not by the 15.75 kc fundamental, but by the sharp "fly-back" interval of that sawtooth wave. That's up in the RF region, equivalent to around 80 kc or so. That's what the HV rect, focus rect etc. were dealing with.

In those days, silicon diodes were not fast enough in those regimes, whereas seleniums were.

Last edited by old_coot88; 11-20-2014 at 07:31 PM.
Reply With Quote