View Single Post
  #18  
Old 11-07-2014, 05:41 AM
Username1's Avatar
Username1 Username1 is offline
Not sure how I got here.
 
Join Date: Dec 2009
Location: Orange County NY
Posts: 3,668
This set does have a service switch, its over by the focus thing.... It's the
one with only 2 positions....

As for the colors.... The Yellow, that is a little green.... It's suppose to be green..
Only new flat screen Sharp tv's have a dedicated yellow.... Not sure how that's going....

For purity adjustments, First turn color off... you are best to leave the service
switch set to normal, full screen. Then with the brightness set somewhat mid point,
move the VHF tuner to a point between stations. You will have to pick a mid-cam
position, not easy to keep that will give you a blank-white screen, no snow....

I don't remember who, maybe RCA, but their service switch was 3 position and one
of the positions was a full white screen with no snow.... Doing it with that line is
just stupid.... they were smokin something when the decided the line was the way to go-

Then turn down the green, and blue screen adjustments. Set the 2 drive adjustments
somewhere mid-point. (or just don't touch them yet.) You should have a red screen....
There are purity rings on the yoke easily visible near the screw clamp. Move one
around and see if the red improves. If it does not easily improve, you may have to move
the yoke forward or back, but try not to do that... I'm not sure if they have only a red
ring, or other colors on that set, so remember where each is, and don't go nuts turning
everything, just move one a 1/4 turn then put it back if it don't change a lot.....
I guess a few of my brain cells for purity on that set are going.... going....

If you get a good solid red, then do the same with green, and blue.... Then re-check.
If you have the Sam's refer to the procedure they have for purity as this set is
off my memory, and it's been more than 20 years.

Once you get pure single color from each gun done one at a time, you can bring
up the red till you see it, then green, then blue, and compare it to a nice
well lit piece of white paper, when you get it right, then you have
basic purity and gray scale set up....

Convergence is next, for this set I would use the tic-tac-toe board, don't bother
with the dots, and just do a overall with the convergence magnets on the tube...
I'm pretty sure the convergence board is not marked, you will
need to refer to the sams for the pots and coils....

.
__________________
Yes you can call me "Squirrel boy"

Last edited by Username1; 11-07-2014 at 06:01 AM.
Reply With Quote