View Single Post
  #2  
Old 11-04-2014, 11:44 AM
drussell drussell is offline
VideoKarma Member
 
Join Date: Feb 2013
Location: Calgary, AB
Posts: 68
Quote:
Originally Posted by YamahaFreak View Post
... Samsung PN51F4500A(FXZA) 50-inch plasma ... built in September of 2013
...
When I plug it in, the red standby LED turns on. If I press the POWER button (on the remote or on the set) the standby LED goes out...and nothing else happens. It's like the set was unplugged. There is no evidence of physical damage, screen doesn't appear to be cracked, everything inside looks good, nothing burnt/fried, etc. No strange sounds...in fact, no noise at all.
I'm also working on a recent Samsung Plasma today, a PN60E530A3F built in January 2013. I ended up bringing it back with me to do more sleuthing as when I checked most of the obvious stuff on-site (in case it was something easy like no voltage due to a blown-up capacitor or other typical Samsung-y problem) but everything I checked seemed fine. This is a bar TV so it sees high hours but the thing isn't even two years old yet (!!) AND by the look of the screw heads and one broken plastic stud, I'm pretty sure someone's been in here before already to repair! Not a good omen! This set just does 6 blinks on a cold-plug-in start attempt then locks out.

As for yours, have you checked the power supply voltages? On most plasmas the power will attempt to come up briefly on plug-in. Check your VS and VA from the power supply and make sure you have low voltage (on most Samsungs thats something like +5.3v and +15v). Do you have voltage (briefly) on all of them at plug-in or power button press?

If you have VS and VA then you can start to check for VScan / Ve, start looking for X or Y board problems, etc. If you don't even have VS and VA and your low voltages, it's going to lock out immediately so that needs to be fixed first.
Reply With Quote