View Single Post
  #18  
Old 09-10-2014, 06:38 PM
dano dano is offline
VideoKarma Member
 
Join Date: Nov 2006
Posts: 53
I've worked on several basket case sets, my only rule of thumb is to make sure it's something I actually like enough to want to keep it in the first place. My thinking is, if it's rough, I likely won't be able to sell it so what have I got to loose? I've repaired bakelite cases by gluing in wire mesh or screen, and then filling the missing pieces in with bondo body filler. I ended up with a 30s Coronado with a fairly nice case, but somebody removed the power/IF transformers and the tuning cap, I had basically an empty chassis. I found a speaker, power transformer, and volume control from my junk parts pile, and got it to where I have a working amp. There have been a few others that I started in on, then used for parts when another one in better condition came along.

On the Philco in question, I would definitely keep the good case and find another chassis, or try to clean up the old one for the short term until a nicer one comes along. Also keep in mind that Philco used the same basic chassis in several sets, I've seen other table sets with the same basic configuration as yours, as well as several consoles with the same basic knob layout. In fact, I have a console chassis you can have if you want. There might be some changes to the tube lineup or to the dial pointer, but the basic sheet metal stamping and circuit is the same. Also, it's been my experience that chassis seem to hold up better than cabinets, so it's easier to find a parts set with a good chassis and broken cabinet than the other way around.
Reply With Quote