|
I've washed quite a few chassis with no ill effects.
There are some rules however.
1. Never allow water to get inside the power transformer (or any transformer that's somewhat sealed, i.e. has end bells) you will never get it dry enough not to short out.
2. Never get the paper covers on filter cans wet, they disintegrate immediately.
3. You should avoid getting the yoke wet, high voltages in there and it will arc if not 100% dry.
4. Flybacks, I've washed a few, it really depends on what type it is and if it's in good shape, the old 40's RCA type survive it fine but stuff with a less well sealed tire might not. Hair fine wires mean no scrubbing allowed.
5. drying in the oven is a good idea, 150-180 degrees for 30 minutes or so seems to be okay, keep an eye out for anything plastic or wax that might melt under that heat.
As always use your best judgement and try it at your own risk!
|