Now that the weather is FINALLY warmer, I started work on the cabinet.
I found the thermistor disc while cleaning out the cabinet. I wonder how many sets were retired because the disc fell out ?
The sides and front are in pretty good shape.
I figure they used a metal mesh bottom for ventilation.
I'll try to touch up all the nicks and dings.
Legs and bottom removed.
It may looks like real mahogany, but I'm pretty sure it's poplar painted red.
Fully disassembled cabinet. I made an attempt to touch up the large area of finish loss on top, but it looks terrible.
So off it comes. Much was scrapped off and liquid stripped used in the stubborn areas.
New paper veneer prepared. I coated both surfaces with TiteBond Wood Glue and allow to dry.
This particular glue can be reactivated with heat for seven days.
Not bad, but I might give it another try. This veneer is so thin that any defect, including variation in glue thickness, is telegraphed onto the surface. It's so thin that they can;t be sanded out.
Finally, after a little Brown Mahogany Mohawk toner. It's a little darker and redder than the original but not bad. If I were to do it again, I'd try Prefect Brown toner instead.