Quote:
Originally Posted by dieseljeep
Did you look into the screen source electrolytics. A lot of times they cause strange looking faults in the raster.
|
there was a .47 on the board on the CRT that supplies the G2, it was a 500v. not having a good way to test at that voltage I just replaced it with a 630v film .47 cap. no change.
my play is to scope the K's of the CRT and see if there is something going on there. I want to isolate the fault to either the kine bias,sweep or HV. I think its the kine bias as there is no distortion in the image that shows thru. I hope scoping the pins of the crt will show the defect at the horz rate.