View Single Post
  #22  
Old 12-20-2013, 10:21 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
looks like you need to adjust the burst amplifier output coil. Looking to see if I can find something for you. if can post a pick of the chassis from the back would help to point it out.

looks like the coil to the right of the 3EJ7 tube. starting from the back it should be the second row of tubes (thinner tubes), the second tube from the left (looking from the rear of the set. To the right of that 3EJ7 should be a coil (from the top of the chassis it is just a hole with pins around it, from the bottom you should see the coil).

That is the burst amp output coil. You need the correct tool (don't improvise here) commonly referred to as a "diddle stick" or TV alignment tool, its a hex shaped plastic tool. You may still find them at rat shack, if not easy to find on ebay.

The idea is to put s piece of masking tape on it to make a flag, so you can see how much you turn. then adj one way and see if the tint shift is correct if not simply reverse. You should not need more than a 1/4 turn so if nothing happens put it back to the starting position. Either that is not the correct coil or something else is wrong. Just don't turn in more than 1/4 and keep track of where you started.

Last edited by DaveWM; 12-20-2013 at 10:33 PM.
Reply With Quote