|
if you turn the color control fully CCW so you have a B&W pic, is the green still there? if you get a good B&W and the issue is not enough tint range (but it is working just not enough range) then you likely need a a slight tweak of the burst detector transformer. I just went thru this on a CTC-12 (had some issues with color in general, replaced the burst amp tube and suddenly the tint was too green. I could have tried another tube but instead I opted t tweak the that transformer.
So you could try some tube swaps 1st (burst amp, or other tube that is in the color circuit that controls the 3.58 mhz osc) or tweak the correct coil. The tweaking should not be done unless you know which coil to tweak which would require a schematic to make sence of it. Never just start tweaking with out knowledge of the circuit and are sure what should be done.
|