|
the width will prob be ok after replacing the old rectifiers. check the B+, higher line voltage found in many locals AND silicon will likely cause excessive B+, take a reading add a 20 ohm in the B+ line, check again... adjust as needed to get where the sams say it should be. Measure the voltage drop across the resistor, measure the current thru the resistor, multiply, for wattage, then oversize by *2 for wattage rating of the resistor.
A little spritz of some of your fav pot cleaning juice should free up the rings.
you rotate then and spread them to effect movement for centering. Your not going to mess anything up, its pretty straight forward (not like purity setup on a color set). The yoke should be snug up against the bell.
|