I did a bit more work on the DuMont. I replaced the few remaining paper caps, including the ones hiding in the small shielded compartment. I also replaced a few more resistors, including the 3.3K in the socket for the 6AL7 indicator tube, which ahd drifted to more the 5K:
I had planned to try the VDC CRT in the set, but I was unable to remove the yoke. It's such a tight fit, that it wouldn't slide over the repaired base of the 17AP4. I was afraid that something like this might happen when I was repairing the base and I thought I had done a good job of keeping things compact. Even after removing the electrical tape, no dice. I was afraid that if I tried too hard that I might damage the yoke, the base or worse. So I abandoned the idea for now. Since the old CRT is making a very nice picture, I can afford to wait. I think what I will need to do is to carefully grind down parts of the base with a Dremel tool. At least I know that the repair I made with the black, sensor safe RTV is nice and sturdy:
With everything back together, the picture is rock solid and the audio is excellent-- lots of bass with the big speaker.